Detroit Conversion Harnesses
$875.00 to $975.00 for most trucks 10 feet long

These harnesses are used to replace mechanical engines with electronic engines. Each wire is colored coded with Twenty color combinations to match the Detroit wiring schematic. Each wire is printed every six inches identifying what circuit it is such as 419 Check Engine Light, 509 Stop Engine Light, 952 Sensor Return. These harnesses are made from the Detroit recommended wire gauge and wire type. Each harness is made to order with the circuits that you specify. Unsure about how you would like your harness configured we are happy to advise and guide you through the decision. We are not just a manufacturer of wiring harnesses we are the experts when it comes to Detroit conversions

Each harness comes with the following:

•

•
•
•
•
•
•
•
•
•

Rubber grommet to route the wiring harness
from the engine compartment into cab.
Check Engine Lamp. Stop Engine Lamp.
Data link connector with cap.
Weather tight bus used for all sensor common wiring.
Fused junction for ignition supply.
Fused power harness with battery terminals
Throttle connector and vehicle speed connectors.
High temperature split loom.
Installation guide and wiring schematic.
Technical support needed to get the job done right.

Detroit/Mercedes-Benz Bypass Harnesses

A Detroit bypass harness is used to communicate with the ECM on or off the engine. Use this harness to run the engine in or out of the truck. The harness is used to bypass the vehicle wiring to the engine ECM.

Click photo to view larger image

		Mercedes-Benz 900 & 4000 Series $600.00
		DDEC III & IV $450.00
		DDEC V $525.00
		DDEC VI $800.00

Detroit Conversion Harnesses $875.00 to $975.00 for most trucks 10 feet long

Detroit Conversion Harnesses
$875.00 to $975.00 for most trucks 10 feet long