Cummins Conversion Harnesses
$875.00 to $975.00 for most trucks 10 feet long

These harnesses are used to replace mechanical engines with electronic engines. Each harness is colored coded with 12 colors. Each wire is printed every six inches identifying what circuit it is such as Check Engine Lamp, Stop Engine Lamp, Sensor Common. These harnesses are made from the Cummins recommended wire gauge and wire type. Each harness is made to order with the circuits that you specify. Unsure about how you would like your harness configured we are happy to advise and guide you through the decision. We are not just a manufacturer of wiring harnesses we are the experts when it comes to Cummins conversions.

Each harness comes with the following:

•

•
•
•
•
•

•
•
•
•

Rubber grommet to route the wiring harness from
the engine compartment into cab.
Check Engine Lamp. Stop Engine Lamp.
Data link connector with cap.
Weather tight bus used for all sensor common wiring.
Fused junction for ignition supply.
Sealed fuses and holders for unswitched battery
inputs or power harness.
Throttle connector and vehicle speed connectors.
High temperature split loom.
Installation guide and wiring schematic.
Technical support needed to get the job done right.

Cummins Bypass Harnesses

The Cummins bypass harness is used to communicate with the ECM on or off the engine. Use this harness to run the engine in or out of the truck. The harness is used to bypass the vehicle wiring to the engine ECM. Note the Celect Plus bypass harness does not have a data link connector. The data link connector is already built into the Cummins engine harness. Note the Cummins Celect and Celect Plus communication harnesses are for communication only, they will not run the engines.

Click photo to view larger image

		Cummins Celect $400.00
		Cummins Celect Communication Harness (Used to communicate with ECM off engine) $400.00
		Cummins Celect Plus $400.00
		Cummins Celect Plus Communication Harness (Used to communicate with ECM off engine) $400.00
		First Generation ISB 23 pin, ISC & ISL $510.00
		First Generation ISM, ISX & Signature $450.00
		Second Generation (EGR) ISB, ISC, ISL, ISM, ISX & Signature $525.00
		2007-2009 ISM ISX $550.00
		2007-2009 ISB ISC ISL $550.00
		2010-Current ISB ISC ISL ISX $550.00

Cummins Conversion Harnesses $875.00 to $975.00 for most trucks 10 feet long

Cummins Conversion Harnesses
$875.00 to $975.00 for most trucks 10 feet long